Juniper SRX 210, Руководство по оборудованию, Страница: 195 / 204

■
Flat-blade screwdriver, approximately 1/4 in (6 mm)
■
Phillips (+) screwdrivers, numbers 1 and 2
Related Topics
Packing the SRX 210 Services Gateway for Shipment on page 175
■
■
Packing the SRX 210 Services Gateway Components for Shipment on page 176
■
Return Procedure for the SRX 210 Services Gateway on page 169
Packing the SRX 210 Services Gateway for Shipment
To pack the SRX 210 services gateway for shipment:
1.
Retrieve the shipping carton and packing materials in which the device was
originally shipped. If you do not have these materials, contact your Juniper
Networks representative about approved packaging materials.
2.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to the ESD point on the chassis or to an outside ESD point if
the device is disconnected from earth ground. For more information about ESD,
see “Preventing Electrostatic Discharge Damage to the Services Gateway” in
“SRX 210 Services Gateway General Safety Guidelines and Warnings” on page 133.
3.
On the console or other management device connected to the services gateway,
enter CLI operational mode and issue the following command to shut down the
services gateway software:
user@host> request system halt
Wait until a message appears on the console confirming that the operating system
has halted.
4.
Shut down power to the device by pressing the power button on the front panel
of the device.
5.
Disconnect power from the device.
6.
Remove the cables that connect to all external devices.
7.
Remove all field-replaceable units (FRUs) from the device.
8.
If the device is installed on a wall or rack, have one person support the weight
of the device while another person unscrews and removes the mounting screws.
9.
Place the device in the shipping carton.
10.
Cover the device with an ESD bag, and place the packing foam on top of and
around the device.
11.
Replace the accessory box on top of the packing foam.
12.
Securely tape the box closed.
13.
Write the Return Materials Authorization (RMA) number on the exterior of the
box to ensure proper tracking.
Related Topics
Required Tools and Parts for Packing the SRX 210 Services Gateway on page 174
■
■
Packing the SRX 210 Services Gateway Components for Shipment on page 176
Packing the SRX 210 Services Gateway for Shipment
■ 175
Appendix E: Contacting Customer Support and Returning the SRX 210 Services Gateway Hardware