Juniper SRX 210, Руководство по оборудованию

Страница: 139 / 204

Figure 23: Installing a Mini-PIM on the SRX 210 Services Gateway
CAUTION: Slide the Mini-PIM straight into the slot to avoid damaging the components
on the Mini-PIM.
Tighten the screws on each side of the Mini-PIM faceplate using a 1/8 inch (3
mm) slotted screwdriver.
4.
Insert the appropriate cables into the cable connectors on the Mini-PIM.
5.
If necessary, arrange the cables to prevent them from dislodging or developing
stress points:
■
Secure the cables so that they are not supporting their own weight as they
hang to the floor.
■
Place any excess cables out of the way in neatly coiled loops.
■
Use fasteners to maintain the shape of the cable loops.
6.
Reconnect the power adapter to the device. Verify that the Power LED glows
steadily green after you press the power button.
7.
Verify that the Mini-PIM LED on the system dashboard glows steadily green to
confirm that the Mini-PIM is online.
Related Topics
■
Required Tools and Parts for Replacing a Mini-Physical Interface Module on the
SRX 210 Services Gateway on page 115
■
Removing a Blank Mini-Physical Interface Module Faceplate from the SRX 210
Services Gateway on page 116
■
Removing a Mini-Physical Interface Module from the SRX 210 Services
Gateway on page 117
■
CLI on the SRX 210 Services Gateway on page 121
Installing a Mini-Physical Interface Module in the SRX 210 Services Gateway
■ 119
Chapter 13: Replacing Mini-Physical Interface Modules on the SRX 210 Services Gateway