Juniper SRX 210, Руководство по оборудованию

Страница: 93 / 204

5.
Secure the grounding cable lug to the grounding points, first with the washers,
then with the screws.
6.
Dress the grounding cable and verify that it does not touch or block access to
the services gateway components and that it does not drape where people could
trip on it.
Related Topics
■
Powering On and Powering Off the SRX 210 Services Gateway on page 73
■
Resetting the SRX 210 Services Gateway
■
Required Tools and Parts for Grounding and Powering On the SRX 210 Services
Gateway on page 71
■
SRX 210 Services Gateway General Safety Guidelines and Warnings on page 133
Powering On and Powering Off the SRX 210 Services Gateway
This topic describes the following procedures:
1. Powering On the SRX 210 Services Gateway on page 73
2. Powering Off the SRX 210 Services Gateway on page 73
Powering On the SRX 210 Services Gateway
To power on the services gateway, insert the DC plug into the DC jack of the device
and insert the AC adapter into the power supply faceplate. The device starts as the
power supply completes its startup sequence. The Power LED lights during startup
and remains on steadily when the device is operating normally.
Powering Off the SRX 210 Services Gateway
To power off the services gateway, you can shut it down in one of the following ways:
■
Graceful shutdown—Press and release the power button. The device begins
gracefully shutting down the operating system and then prints “press any key
to reboot.”
■
Immediate shutdown—Press the power button and hold it for ten seconds. The
device immediately shuts down. Press the button again once to power on the
device.
Powering On and Powering Off the SRX 210 Services Gateway
■ 73
Chapter 9: Grounding and Powering On the SRX 210 Services Gateway