Juniper MEDIA FLOW MANAGER 2.0.2 - ADMINISTRATOR S GUIDE AND CLI, Руководство администратора

Страница: 68 / 156

CHAPTER 3 Media Flow Manager Web-Based Interface Media Flow Manager Administrator’s Guide
68 CMC Setup Copyright © 2010, Juniper Networks, Inc.
CMC Setup
Configure the Central Management Console. As administrator of a Media Flow Manager, in
addition to all normal system setup (interfaces, email notifications, etc.; see
System Config
)
you have the following decisions to make and tasks to perform, at a minimum.
CMC Setup > Media Flow Controllers
Use this page to add Media Flow Controllers to CMC for management. Once you add an
appliance in this way, the configuration options for that appliance become greyed-out unless
you log in to the appliance through the CMC. For Media Flow Controller details, see
“Configuring CMC (Central Management Console) Options” on page 70 of the
Media Flow
Controller Administrator’s Guide and CLI Command Reference
.
CMC - Media Flow Controller
This list of currently managed Media Flow Controllers includes the following information for
each. See
Figure 58 , next, for graphic.
•
Name
—The name you configured as the
Media Flow Controller ID
when you added it.
•
Address
—The IP address of the Media Flow Controller.
•
Groups
—Any defined Group that the Media Flow Controller belongs to (can belong to
more than one).
•
Enabled
—Whether or not monitoring of this Media Flow Controller is enabled.
•
Status
—The latest status report of this Media Flow Controller.
•
Comment
—The comment you entered for the Media Flow Controller when you added it.
Use
Remove
to delete the selected Media Flow Controllers from CMC management;
Disable
to temporarily stop CMC from managing the selected Media Flow Controllers;
Enable
to allow
Table 2 CMC Setup Considerations and Tasks
Consideration Task
Which Media Flow Controllers do you want to
manage with this Media Flow Manager?
CMC Setup > Media Flow Controllers
What groups of Media Flow Controllers do you
want to create (if any)?
CMC Setup > Groups
In addition to manually adding Media Flow
Controllers, you can set up a rendezvous
mechanism that causes properly configured Media
Flow Controllers to initiate connection to server
themselves. Do you want to use rendezvous ?
CMC Setup > Rendezvous
What profiles (sets of commands) do you want to
create and how? You can create profiles via a
configured Media Flow Controller or by manually
entering commands.
Create Profiles
What nodes or groups do you want to apply your
profiles to?
CMC Profiles > Apply Profile