Juniper JRR200, Руководство по оборудованию

Страница: 45 / 108

•
Check that the power supplies are fully inserted into the chassis.
To connect AC power:
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to the ESD point on the rear of the chassis.
2.
Locate the power cords shipped with the JRR200 route reflector; the cords have plugs
appropriate for your geographical location.
3.
Set the power switch on the JRR200 route reflector to the off (
O
) position.
4.
Insert the coupler end of the power cord into the AC power cord inlet on the AC power
supply faceplate. Push the power cord retainer onto the power cord.
NOTE: An AC-powered device gets additional grounding when you connect
the power supply in the device to a grounded AC power outlet by using
the power cord.
5.
Insert the power cord plug into an AC power source outlet.
6.
Repeat steps 4 and 5 for the second AC power supply.
7.
Dress the power cord appropriately. Verify that the power cord does not block the air
exhaust and access to JRR200 route reflector components or drape where people
could trip on it.
8.
If the AC power source outlet has a power switch, set it to on (|) position. Set the
power switch on the JRR200 route reflector to the on (|) position and it will power
on.
•
•
If there is no power switch on the AC power source outlet, set the power switch on
the JRR200 route reflector to the on (|) position and it will power on.
9.
Verify that the AC and DC LEDs on each power supply are lit green.
45 Copyright © 2018, Juniper Networks, Inc.
Chapter 3: Initial Installation and Configuration