Juniper JRR200, Руководство по оборудованию

Страница: 42 / 108

•
Phillips (+) screwdriver, number 2
• Two persons are required for mounting the JRR200 route reflector.
NOTE:
•
Ensure that the rack is in its permanent location, allowing adequate
clearance for airflow and maintenance, and secured to the building
structure.
•
If you are mounting multiple units in the rack, mount the heaviest unit at
the bottom and mount the others from bottom to top in order of decreasing
weight.
CAUTION: Wrap and fasten one end of the ESD grounding strap around your
wrist and connect the other end to a site ESD point.
NOTE: Ensure that the rear of the JRR200 route reflector is supported
throughout the process of mounting the route reflector into the rack.
To mount the JRR200 route reflector on a four-post rack:
1.
Attach the front-mounting brackets and the side mounting rails to the chassis by using
the flat-head screws.
Figure 12: Attaching the Mounting Ears and Fixed Brackets
g100081
NOTE: Ensure that the rear of the device is supported throughout the
process of mounting the device into the rack.
2.
Have one person grasp both sides of the JRR200 route reflector, lift it, and position it
in the rack so that the front mounting bracket holes align with the threaded holes in
the rack rail and the second person secure the front of the JRR200 route reflector to
the rack by using rack-mounting screws (and cage nuts and washers if your rack
requires them).
Copyright © 2018, Juniper Networks, Inc. 42
JRR200 Route Reflector Hardware Guide