Juniper JRR200, Руководство по оборудованию

Страница: 19 / 108

JRR200 Route Reflector Chassis Status LEDs
Figure 2 on page 19 shows the chassis status LEDs that are located on the front panel
of the JRR200 route reflector. Table 4 on page 19 describes the LEDs.
Figure 2: JRR200 Route Reflector Chassis Status LEDs
g100085
Power
Status
SSD
Table 4: JRR200 Route Reflector Chassis Status LEDs
Description LED
•
Solid green—receiving power Power
• Solid green—operating normally
• Solid red—critical alarm
• Hardware component failure
• Software module failure
• Fan failure (atleast one)
• Blinking red—noncritical alarm
• Off—the system is not receiving power
Status
•
Blinking green—indicates hard disk drive (SSD) activity SSD
Management Port LEDs
The management port has two LEDs that indicate link activity and status of the
management port.
Table 5 on page 19 describes the LEDs.
Table 5: Management Port LEDs
Description LED
• Solid amber—A link is established, but there is no activity on the link.
•
Blinking amber—There is link activity.
• Off—There is no link established.
Link/Activity (LED
on the left)
• Solid green—100-Mbps link is established.
• Solid amber—1000-Mbps link is established.
• Off—There is no link established.
Speed (LED on the
right)
19 Copyright © 2018, Juniper Networks, Inc.
Chapter 1: Overview