Juniper BX7000, Руководство по оборудованию, Страница: 75 / 138

Troubleshooting the Advanced Clocking Module 57
CHAPTER 9: Troubleshooting
Temperature
Instance : 0 Current Temperature(in Celcius) : 49
Instance : 1 Current Temperature(in Celcius) : 50
z
If the system LED on the front panel is lit red, use the show chassis alarms command to get
information about the source of an alarm condition and to get the status of the alarm.
cli@BX7000>
show chassis alarms
11 alarms are currently active
Alarm time Class Description
2000-01-01 00:01:55 UTC Other e1-0/0/0 : RED
2000-01-01 00:01:55 UTC Other e1-0/0/0 : Loss of Frame
2000-01-01 00:02:00 UTC Other e1-0/0/1 : RED
2000-01-01 00:02:00 UTC Other e1-0/0/1 : Loss of Frame
2000-01-01 00:01:55 UTC Other e1-0/0/0 : Alarm Indication
Signal
2000-01-01 00:02:00 UTC Other e1-0/0/1 : Loss of Signal
2000-01-01 00:01:48 UTC Other gige-1/0/1 : Link Down
Troubleshooting the Advanced Clocking Module
If the card is not inserted properly in the Clock Card Expansion Bay slot, the POST displays the error
message “card is not detected.”
To troubleshoot:
1. Turn off the gateway.
2. Remove the card from its slot and reinstall the card into the slot.
3. After the gateway reinitializes, the card should be detected during POST.
4. If the POST again displays the message “card is not detected,” the gateway has detected a
hardware failure.
5. Contact the Juniper Networks Technical Assistance Center (JTAC) for instructions.