Jungheinrich 50435801, Руководство по эксплуатации

Страница: 29 / 83

11
06
.G
B
E 6
3 Starting up the truck
F
Before starting or operating the truck, or before lifting any loads, the driver has to
make sure that nobody is within the danger area.
The electronic drive control system and the steering control system (option) are au-
tomatically monitored for proper functioning. In case of an error, driving and steering
are interrupted.
F
The error that occurred must be eliminated by the manufacturer's service.
Checks and operations to be performed before starting daily work
– Visually check the entire truck (especially the wheels and the lifting device) for vis-
ible damage.
– Visually check the battery attachment and the cable connections.
M
When mounting the truck, make sure that the controller and the operating key
“Pedestrian” (
o
) are not actuated.
Switching on the truck
– Step onto the standing platform.
– Push down the control shaft adjusting lever, swivel the control shaft to the desired
position and release the control shaft adjusting lever again.
– Pull out the master switch (1).
– Enter code into the code lock (
o
) (12), if required, actuate key switch (14).
– Check the horn (2) for correct functioning.
– Check the controller (6) for correct functioning (refer to section 4.3).
The truck is now ready for operation.
Z
The display instrument (CANDIS (13) (
o
)) shows the available battery capacity.
1
12
6
13
2
R
R
V
V
14
11
06
.G
B
E 6
3 Starting up the truck
F
Before starting or operating the truck, or before lifting any loads, the driver has to
make sure that nobody is within the danger area.
The electronic drive control system and the steering control system (option) are au-
tomatically monitored for proper functioning. In case of an error, driving and steering
are interrupted.
F
The error that occurred must be eliminated by the manufacturer's service.
Checks and operations to be performed before starting daily work
– Visually check the entire truck (especially the wheels and the lifting device) for vis-
ible damage.
– Visually check the battery attachment and the cable connections.
M
When mounting the truck, make sure that the controller and the operating key
“Pedestrian” (
o
) are not actuated.
Switching on the truck
– Step onto the standing platform.
– Push down the control shaft adjusting lever, swivel the control shaft to the desired
position and release the control shaft adjusting lever again.
– Pull out the master switch (1).
– Enter code into the code lock (
o
) (12), if required, actuate key switch (14).
– Check the horn (2) for correct functioning.
– Check the controller (6) for correct functioning (refer to section 4.3).
The truck is now ready for operation.
Z
The display instrument (CANDIS (13) (
o
)) shows the available battery capacity.
1
12
6
13
2
R
R
V
V
14