Jungheinrich 50435801, Руководство по эксплуатации

Страница: 42 / 83

E 19
11
06
.G
B
5.4 Parameter settings
To change the truck settings the master code must be entered.
Z
The master code is factory-set to 7-2-9-5.
M
Change the master code when setting the truck into operation for the first time (refer
to section 5.1).
F
Safety notes for trucks with indicator instrument (CANDIS (
o
))
– Parameter settings must be made carefully and only by special trained personnel .
If in doubt, consult the manufacturer's service.
– Every setting procedure must be monitored on the LC display of the indicator
instrument (CANDIS (
o
)). If in doubt, the setting procedure must be cancelled by
pressing the
o
-key (26).
– Since the truck's travel behaviour is changed, you must perform a trial in a specially
assigned and suitable working area run after changing any of the parameters.
Entering the master code:
– Press the
o
-key
– Enter master code
Code lock parameters
Setting procedure for trucks without indicator instrument (CANDIS (
o
)):
– Enter the three-digit parameter number and confirm with Set key (22).
– Enter or change the setting value according to the parameter list and confirm with
Set key (22).
Z
When the input is incorrect, the LED (21) of the
o
-key (26) lights up red. After
entering the parameter number again, the setting value can be entered or changed.
Repeat the procedure to enter further parameters. To terminate the input, press the
o
-key (26).
Display instrument
(CANDIS)
LED (21)
o
-key
LED (23)
Key 1
LED (24)
Key 2
LED (25)
Key 3
Operating hours
are indicated
284
.
0
green
flashing
off off off
E 19
11
06
.G
B
5.4 Parameter settings
To change the truck settings the master code must be entered.
Z
The master code is factory-set to 7-2-9-5.
M
Change the master code when setting the truck into operation for the first time (refer
to section 5.1).
F
Safety notes for trucks with indicator instrument (CANDIS (
o
))
– Parameter settings must be made carefully and only by special trained personnel .
If in doubt, consult the manufacturer's service.
– Every setting procedure must be monitored on the LC display of the indicator
instrument (CANDIS (
o
)). If in doubt, the setting procedure must be cancelled by
pressing the
o
-key (26).
– Since the truck's travel behaviour is changed, you must perform a trial in a specially
assigned and suitable working area run after changing any of the parameters.
Entering the master code:
– Press the
o
-key
– Enter master code
Code lock parameters
Setting procedure for trucks without indicator instrument (CANDIS (
o
)):
– Enter the three-digit parameter number and confirm with Set key (22).
– Enter or change the setting value according to the parameter list and confirm with
Set key (22).
Z
When the input is incorrect, the LED (21) of the
o
-key (26) lights up red. After
entering the parameter number again, the setting value can be entered or changed.
Repeat the procedure to enter further parameters. To terminate the input, press the
o
-key (26).
Display instrument
(CANDIS)
LED (21)
o
-key
LED (23)
Key 1
LED (24)
Key 2
LED (25)
Key 3
Operating hours
are indicated
284
.
0
green
flashing
off off off