JUKI MO-6800D/DD20 Series, Инструкция по эксплуатации

Страница: 50 / 77

– 47 –
Function setting No. P043: Used for setting the number of revolutions of the main shaft in the case of
manual thread trimming.
P043 Setting range: 500 - 7000 [sti/min] <10 sti/min>
(Caution) This function setting number is enabled only when "DD22" is selected with the
"P125 Model selection (setting of this function is enabled under the Service lev -
el). The main shaft will not rotate at a speed that exceeds the maximum sewing
speed set with the "P001 Maximum sewing speed".
Function setting No. P044: Used for setting the number of times of thread trimming in the case of the
manual thread trimming.
P044 Setting range: 1 - 5 times
(Caution) This function setting number is enabled only when "DD23" is selected with the
"P125 Model selection (setting of this function is enabled under the Service level).
Function setting No. P045: In the case the function setting number "P044 Number of times of manual
thread trimming" is set to two or more, the interval between two consecutive times of thread trimming can
be set with the function setting number P045.
P045 Setting range: 30 - 990 [ms]
(Caution) This function setting number is enabled only when "DD23" is selected with the
"P125 Model selection (setting of this function is enabled under the Service level).
If a short interval is set, the knife may fail to operate in time, resulting in poor
trimming of the thread. Set the thread trimmer operation interval appropriately.
Function setting No. P054: Used for selecting the type of the suction operation for manual thread trim -
ming.
P054 0: OFF
1: Rear suction
2: Front and rear suction
(Caution) In the case the suction operation for manual thread trimming is different from
the operation set with the "P049 Automatic suction ON/OFF", both suction oper -
ations will be carried out separately.
Function setting No. P055: Used for setting the suction time for manual thread trimming.
P055 Setting range: 0 - 200 [ms]
(Caution) In the case the "DD22" is set selected with the "P125 Model selection (setting of
this function is enabled under the Service level), suction operation will be car -
ried out continuously the hand switch is held pressed.
Even if the duration elapsed from pressing to releasing the hand switch is shorter than the set value of
the P055, the suction device will operate during the time set with this function setting number P055.
⑪ Selection of the automatic suction function (Function setting No. P049)
The type of the automatic suction operation can be selected.
P049 0: OFF
1: Front suction
2: Rear suction
3: Front and rear suction
The setting of the automatic suction function can also be changed by pressing button ❼ on the
operation panel. When the front suction, rear suction or the front and rear suction is selected, G is
displayed on the operation panel.
Function setting No. P050: Used for setting the number of stitches to be sewn continuously before the
front suction device stops after the intermediate sensor has detected the material.
P050 Setting range: 0 - 50 stitches