JUKI MO-6800D/DD20 Series, Инструкция по эксплуатации

Страница: 28 / 77

– 25 –
Ａ
(2) Adjusting the lift amount of the presser foot
1) Turn the pulley to lower the feed dog until the bottom of the presser horizontally comes in contact with the
throat plate.
2) Provide a 1 mm clearance between presser foot lifting arm
❶
and fixing bracket
❷
. This clearance can
be adjusted by slightly loosening screw ❸ .
3) Loosen nut ❹ . Press presser foot lifting lever ❻ to lift the presser foot from the throat plate surface. The
lift of the presser foot differs with the model. Adjust the lift of the presser foot according to the model re -
ferring to the table shown below.
Then, adjust screw ❺ so that it comes in contact with presser foot lifting lever ❻ . Tighten nut ❹ .
4) After all the adjustments above, please tighten the screw ❸ .
1 mm
❷
❶
❸
❻
❺
❹
Model Lift amount of the presser foot (A)
MO-6804 6
MO-6814-2 △ H 5.5
MO-6814-3
△
H 5.5
MO-6814-4 △ H 7
MO-6814-30P 5
MO-6816-3 △ H 5.5
MO-6816-50H 6.5
MO-6816-60H 7
MO-6816-30P 5
(Unit : mm)
* This figure gives an illustration of the MO-6814S