JUKI MO-6800D/DD20 Series, Инструкция по эксплуатации

Страница: 65 / 77

– 62 –
Ⓐ
Ⓒ
Ⓔ
Ⓓ
Ⓑ
❷
6-14. Pedal operation
[Pedal operation under the semi-automatic mode
(factory-set at the time of shipment)]
1) Lightly depress the front part of the pedal to car -
ry out low-speed sewing. Ⓑ
2) Further depress the front part of the pedal to car -
ry out high-speed sewing. Ⓐ
3) Put your foot lightly on the pedal to stop the sew -
ing machine.
Ⓒ
(The needle stop position differs depending on
the setting of the relevant function you have se
-
lected on the operation panel. Refer to the expla -
nation of the function setting for details.)
4) Depress the back part of the pedal during sewing to lift the presser foot. Ⓓ , Ⓔ
5) Depress the pedal after the completion of sewing to lift the presser foot. Ⓓ , Ⓔ
* Operation to lift the presser foot or stop the needle differs depending on the relevant function setting.
The sewing machine has been factory-set to the semi-automatic mode. The operation mode can be
changed to the full automatic mode or manual mode by setting the relevant function appropriately.
[Full automatic mode]
When you change the status of the power switch from "OFF" to "ON", the characters [PEdL] appears on
the operation panel.
Depress the back part of the pedal to place the sewing machine in the sewing state. Ⓓ , Ⓔ
While the front sensor is blocked, depress the front part of the pedal to start the sewing machine. Ⓐ , Ⓑ
If you lift your foot off the pedal to return it to the stop position swiftly, the sewing machine may malfunc -
tion depending on the relevant function setting. Ⓒ
Carry out the operation to start and stop the sewing machine without lifting your foot off the pedal.
Ⓐ
,
Ⓑ
,
Ⓒ
* Memory switch P17: In the case the start mode is changed from "1" to "0", the sewing machine will start
running even if you do not depress the front part of the pedal when the sensor is blocked. Added care
should be taken in this mode. The method to temporarily stop the sewing machine remains the same.
Depress the back part of the pedal to make a temporary stop. Ⓓ , Ⓔ
* In the case the main shaft stops rotating before the material is fed to the next sensor after the sewing
machine has sewn the number of stitches set with the parameter "P024 Number of stitches between sen -
sors", the sewing machine will re-start sewing when you depress the front part of the pedal. Ⓐ , Ⓑ
When you depress the back part of the pedal during
sewing, the sewing machine stops and the characters
[SToP] appear on the operation panel.
Ⓓ , Ⓔ
If you want to re-start sewing, press ❷ on the
operation panel to reset the previous operation, then de-
press the front part of the pedal to re-start sewing.
Ⓐ
,
Ⓑ
* Presser foot lifting operation, needle operation,
thread trimming operation and suction operation
differ depending on the setting of the relevant func -
tions. (Refer to the explanation of the function set -
ting for details.)
* Be aware that the sewing machine will start sewing
when the front sensor is blocked not only by the ma -
terial but also by other obstacle.