JUKI MO-6800D/DD20 Series, Инструкция по эксплуатации

Страница: 15 / 77

– 12 –
Single phase 220 to 240V
❶
3-8. Power switch
1) Turning the power ON with the power switch ❶
The power to the sewing machine is placed in
the ON state when the "|" mark side of power
switch ❶ (1ø 220 - 240V type) is pressed; or in
the OFF state when the "○" mark side is pressed.
1. Do not strongly tap the power switch by hand.
2. If the power indicator LED on the panel does not light up after having turned ON the power
switch ❶ , immediately turn OFF the power switch and check the supply voltage.
When you want to re-turn ON power switch
❶
after carrying out the aforementioned steps, it is
necessary to wait for five minutes or more after you have turned OFF power switch ❶ .
3. Do not place your hand or anything under the needle since the needle bar may automatically
move according to the memory switch setting when you turn ON the power to the sewing ma -
chine.
4. When you turn ON the power to the sewing machine while the full automatic mode is set se -
lected, the sewing machine will not start sewing for the sake of safety as long as the front
sensor is blocked.
If you want to re-start sewing under the full automatic mode, remove the obstacle that blocks
the front sensor, block the front sensor again with the material to be sewn and depress the
front part of the pedal once.
5. When you turn ON the power to the sewing machine
while the full automatic mode is set selected, "PEDL"
will be displayed on the operation panel as shown in the
figure on the left.
If you want to start sewing, depress the front part of the
pedal once.
6. When you turn ON the power to the sewing machine for
the first time after purchase, the sewing machine will
start under the semi-automatic mode for the sake of
safety.
Change the mode from the semi-automatic mode to any
sewing mode you want to use.
Refer to "6-5. Details of setting of the main functions"
p.41 for details of the changes made to the sewing ma -
chine.