122
@0
Function of pedal curve selection (Function setting No.87 F-PCS)
This function can perform the selection of the curve of number of rotation of the sewing machine against
the depressing amount of the pedal.
Change to this function when you feel that inching operation is hard or that pedal response is slow.
0 : Number of rotation of the sewing machine in terms of
the depressing amount of the pedal increases linearly.
1 : Reaction to intermediate speed in terms of the
depressing amount of the pedal is delayed.
2 : Reaction to intermediate speed in terms of the
depressing amount of the pedal is advanced.
!9
Function to select the start-up speed of the sewing machine (Function setting No.76 F-SCS)
This function is selected in the case where the speed of the sewing machine is desired to be more at the
time of start-up. (Time required to start is shortened by approximately 10%.)
0 : Normal curve
1 : More sharp curve
If “1” is set, motor may move irregularly. In addition, noise may occur when the sewing
machine is running or noise may increase when the sewing machine is running.
!8
Retry function (Function setting No.73 F-RET)
When the retry function is used, if the sewing material is thick and not piereced with needle, this function
makes the needle pierce in the material with ease.
0 : Normal
1 : Retry function is provided.
External interface means the section to connect the operation panel and the system which is different from
the operation panel.
For the use and details of function, please ask our business office.
(1) Media slot
Media slot is installed in the face cover located on the left side of operation panel.
(2) RS-232C port
RS-232C connector is installed in the rubber cap located on the back side of operation panel.
(3) General input port (Production control switch connecting connector)
General input connector, CN105 is installed in the cord outlet cover located on the back side of operation panel.
@1
Function added to the needle up / down compensating switch (Function setting No.93 F-MADF)
One stitch operation can be performed only when the needle up / down compensating switch is pressed
at the time of upper stop immediately after turning ON the power switch or upper stop immediately after
thread trimming.
0 : Normal (Only needle up / down compensating stitching operation)
1 : One stitch compensating stitching operation (upper stop
/
upper stop) is performed only
when aforementioned changeover is made.
@2
Setting of max. number of rotation of the sewing machine head (Function setting No.96 S-MAX)
This function can set the max. number of rotation of the sewing machine head you desire to use.
Upper limit of the set value varies in accordance with the sewing machine head to be connected.
50 to Max. [sti/min]
6-18. External interface
Number
of
rotation
(sti/min)
Pedal stroke (mm)
0
1
2
