9
3) Remove four screws fixing the rear cover of
the electrical box.
(caution) Do not touch other screws.
When opening the rear cover, pressing it with your
hands, slowly open it by approximately 70˚ until it
stops as illustrated.
(1) Preparation of wiring
1) Pass the cords coming from the machine head to
the underside of the table through hole A in the
table.
2) Loosen screws D and lift cord presser plate C of
cord passing hole B located on the front cover to
the top and temporarily tighten the plate.
Be sure to lend your hand to the
rear cover in order not to let the rear
cover fall. In addition, do not apply
force to the rear cover opened.
a
c
B
D
4-8. connecting the cords
WarNING :
• to prevent personal injury caused by abrupt start of the sewing machine, carry out the work after turning
oFF the power switch and a lapse of 5 minutes or more.
• To prevent damage of device caused by maloperation and wrong specifications, be sure to connect all the
corresponding connectors to the specified places.
• to prevent personal injury caused by maloperation, be sure to lock the connector with lock.
• as for the details of handling respective devices, read carefully the Instruction Manuals supplied with the
devices before handling the devices.
How to remove the cord clamp
1
lightly pressing
2
Pull down the clamp.
3
the clamp goes up.
* See P.14 for how to lock the cord clamp.
4) Remove the locks of cord clamps a, b, c, d, e, f and j.
slowly
j
c
b
a
e
f
d
E
2
3
1
1
