SECTION
PAGE
2 - 17
1
(A)
( 1 )
( 2 )
NOTE: Before checking, follow Section 2 - 3 "Needle position at Zigzag
Stitching (Vertical movement)", 2 - 9 "Feed Dog Timing", 2 - 15
"Needle Height".
Adjustment:
1. Remove bottom cover of free arm.
2. Touching the side of lower shaft gear (1) with finger to hold it in place, loosen
two screws (2).
3. Turn lower shaft gear (1) in either direction to correct the condition.
4. After the adjustment, tighten 2 screws (2) firmly.
Checking:
1. Remove bobbin case and needle plate.
2. Set stitch width control at the maximum and stitch selector at zigzag stitch.
3. Turning hand wheel, bring up needle from its left hand lowest point until shuttle
hook point comes to align with right side of needle.
Check if clearance (A) between hook point and upper edge of needle eye is
0.7 - 1.0 mm.
2 - 17 Needle Timing to Shuttle
Содержание HZL-35Z
Страница 1: ...SEWING MACHINE HZL 35Z SERVICE MANUAL ...