JUKI HZL-35Z, Руководство по обслуживанию

Страница: 16 / 34

SECTION
PAGE
0.35
( 1 )
Terminal cover
( 2 )
( 3 )
2 - 6
1
2 - 6 Clearance between Zigzag Cam and Cam Follower
Checking:
1. Remove presser foot.
2. Set machine at maximum zigzag width.
3. Lower needle to its left lowest position.
4. Turn selector dial towards you (anti-clockwise) and set it between "zigzag
stitching" and "blind stitching".
5. Check if needle point shifts a little from above "3" position to left.
Adjustment:
1.
2. Adjust by turning screw (3).
Needle shift is zero or too little. Æ Turn screw clockwise.
Needle shift is too much. Æ Turn it anti-clockwise.
Remove two screws on terminal cover.
shift amount