JUKI AMS-221EHL, Руководство пользователя

Страница: 35 / 235

– 31 –
* Turn ON the power once, and turn OFF the power again after
making the intermediate presser in the lowered state.
1. Turn hand wheel by hand to ascend the needle bar .
Adjust so that lower marker line on the ascending needle bar aligns
with the bottom end of the needle bar bushing lower .
2. Loosen setscrew in the driver. Drawing bobbin case opening lover
hook toward you, open it to the right and left until bobbin case
opening lover comes off.
(Caution) At this time be careful not to let inner hook come off
and fall.
3. Refer to 5. below and make tentative adjustments of timing for the
inner hook .
4. Turn the pulley by hand and make adjustments for the needle loca-
tion block of the driver by bending it in the direction of Arrow A so
that the clearance b attains 0mm to 0.5mm between the needle tip
and the lowest end of the needle location block of the driver when
the needle tip of the inner hook is protruded by 0.5mm from the
right end of the needle .
5. Make an adjustment so that the blade point of the inner hook is
aligned with the center of the needle , and that the clearance be-
tween the front end of the driver and the needle is 0 mm be-
cause the front end of the driver receives the needle to prevent
needle bending. Then, tighten the setscrew securing the driver.
6. Make adjustments so that the clearance (C) in the revolving direction
attains 0.3mm to 0.6mm between the inner hook and the driver
by bending the inner hook holder block (reverse side of the needle
location block) of the driver in the direction of the arrow (D).
(Caution) Make sure not to damage the shuttle race plane while
making adjustment of the driver .
7. Loosen the setscrew securing the shuttle , and adjust the front-
rear position of the shuttle by rotating the shuttle adjusting shaft
so that the clearance between the needle and the blade point of
the inner hook becomes 0.05 to 0.1 mm.
8. After adjusting the front-rear position of the shuttle , set the clear-
ance between the needle and the shuttle to 7.5 mm by adjust-
ing the rotating direction, and tighten the setscrew securing the
shuttle.
Adjustment Procedures Results of Improper Adjustment