JR XP6102, Инструкция по эксплуатации

Страница: 37 / 90

www.modelflight.com.au – World’s best source of JR products
AILERON TO RUDDER MIXING
6G
This form of mixing is designed so that
when input to the aileron stick is given,
the rudder servo will also move,
eliminating the need to coordinate these
controls manually.
When adjusting, if an opposite mixing
direction of the rudder servo is required,
simply press the (+) or (-) keys to change
the mixing value from a (+) to (-). This will
reverse the mixing direction of the rudder
from its original direction. The switch
used to activate this mix can also be
selected as explained below. The factory
default is a value of 0%.
Go to Throttle Cut menu
Change value/Select switch
[AIL RUD MIX]
ON
VAL 0%
SW ALWAYS ON
Go to Ele v Flp Mx
Change selection
Reset selection to Default
Accessing the Aileron to Rudder Mixing Function
1. Place the transmitter power switch in
the On position.
2. Access the Function mode. To do
so, press the
D o w n
and
Select
keys simultaneously. Press either
the
U p
or
D o w n
key until
AIL v RUD MIX appears in
the center portion of your LCD.
3. Press the (+) or (-) key to increase
or decrease the amount of rudder to
be mixed with aileron. If you want to
reverse the Rudder Mix direction,
press the Clear key, bringing the
mixing value to the factory default (0%),
and increase the value using the
opposite key (+) or (-) from the key
originally selected.
4. Press the
Select
key to access the
switch assignment function.
5. Press the (+) or (-) key to select the
desired switch/function to activate the
Aileron-to-Rudder Mixing function.
6. Access the ELE v FLP MX
mixing function by pressing the
D o w n
key.
7. Access the THRO CUT function by
pressing the
U p
key.
8. Exit the AIL v RUD MIX
function by pressing the
D o w n
XP6102 - Airplane Manual 37