JR XP6102, Инструкция по эксплуатации

Страница: 22 / 90

www.modelflight.com.au – World’s best source of JR products
Elevon Type Selection
Elevon Wing Mixing is available as an
option with your XP6102. This style of
aircraft also employs two wing servos.
However, there is not an elevator
present. Instead, an elevator stick input
causes the two wing servos to function in
conjunction with one another to change
the pitch movement of the aircraft. Also,
when an aileron control is given, the two
wing servos move in opposition to one
another to function as ailerons.
Connect left servo
to the aileron port
of the receiver Connect right servo
to the elevator port
of the receiver
Accessing and Utilizing the Elevon Type Selection
1. While the
D o w n
and
Select
keys are
pressed, move the power switch to
the On position to access the
System mode.
2. Press either the
U p
or
D o w n
key until
WING TYPE appears on the LCD.
3. Press the
Select
key to select the
Elevon function.
4. Press either the (+) or (-) key to turn
on the Elevon Wing Type function.
Note : The Elevon function requires one
servo for each elevon, i.e. a separate
servo for each wing half.
5. Plug the left elevon servo to the
aileron (AILE) of your JR receiver.
Connect the right elevon servo into the
elevator (ELEV) port of your receiver.
6.Check to make sure the servos move
in the proper direction. When an input is
given from the elevator stick, they should
move in unison to achieve the proper
up/down elevator command. If your
servos do not move as described above,
use the Servo Reversing function to
reverse the travel direction.
Note : Each
servo's direction is adjusted
individually through the Servo
Reversing function. For more
information, refer to the Servo
Reversing section in this manual.
7. Once the servos direction has been
set, adjust their travel direction, travel
volume, dual rates, sub-trim and
aileron differential.
Note : The applicable channel's left or
right, up or down travel adjustments
can be made individually. Refer to
the Travel Adjust section in this
manual for more information.
8. Relative to the note above, each
servo's travel volume is automatically
reduced to 75% of the operating range.
This is to ensure that the servo does
not operate beyond its capabilities.
Failure to observe extreme caution
when adjusting the value for the elevon
servos may result in damage to the
servos by over traveling.
Note : Fine adjustments of the elevons
should be made in the Dual-Rate
function. For more information, refer
to the Dual-Rate section in this
manual. You can also adjust the
neutral point of your elevon servos
individually using the Sub-Trim
function as described in the Sub-
Trim section of this manual.
Differential is offered for the elevon
function of your XP6102. For more
information, refer to the Differential
Aileron Mixing section of this
manual.
9. Press the
D o w n
key to access the
SWITCH SEL function.
10. Press the
U p
key to access the
MODEL SEL function.
11. To exit the WING TYPE function,
press the
D o w n
and
Select
keys simultaneously.
22 XP6102 - Airplane Manual