JR XP6102, Инструкция по эксплуатации

Страница: 23 / 90

www.modelflight.com.au – World’s best source of JR products
V-Tail Type Selection
V-tail mixing is available as an option
with your XP6102. V-Tail equipped
aircraft require two servos.
Connect this servo
to the elevator port
of the receiver Connect this servo
to the rudder port
of the receiver
Accessing and Utilizing the V-Tail Type Selection
1. While the
D o w n
and
Select
keys are
pressed, move the power switch to the
On position to access the System
mode.
2. Press either the
U p
or
D o w n
key until
WING TYPE appears on the LCD.
3. Press the
Select
key to select the
V-Tail function.
4. Press either the (+) or (-) key to turn
on the V-Tail Wing Type function.
5. Connect the servo that controls the left
tail control surface to the elevator (#3)
channel in the receiver and the servo that
controls the right control surface to the
rudder (#4) channel in the receiver.
Note :
Individual functions like reversing,
travel adjust, dual rates, sub trims
etc. are available for each servo
independently.
6.Check to make sure the servos move
in the proper direction. When an input is
given from the elevator stick, they should
move in unison to achieve the proper
up/down elevator command. If your
servos do not move in the correct
direction, use the Servo Reversing
function to reverse the travel direction.
Note : Each servo's direction is adjusted
individually through the Servo
Reversing function. For more
information, refer to the Servo
Reversing section in this manual.
7. Once the servos direction has been
set, adjust their travel direction, travel
adjust, dual rates, sub-trim.
Note : The applicable channel's left or
right, up or down travel adjustments
can be made individually. Refer to
the Travel Adjust section in this
manual for more information.
8. Relative to the note above, each
servo's travel volume is automatically
reduced to 50% of the operating range.
This is to ensure that the servo does
not operate beyond its capabilities.
Failure to observe extreme caution
when adjusting the value for the elevon
servos may result in damage to the
servos by over traveling.
Note : Fine adjustments of the V-Tail
should be made in the Dual-Rate
function. For more information, refer
to the Dual-Rate section in this
manual. You can also adjust the
neutral point of your V-Tail servos
individually using the Sub-Trim
function as described in the Sub-
Trim section of this manual.
9. Press the
D o w n
key to access the
SWITCH SEL function.
10. Press the
U p
key to access the
MODEL SEL function.
11. To exit the WING TYPE function,
press the
D o w n
and
Select
keys simultaneously.
XP6102 - Airplane Manual 23