JR XP6102, Инструкция по эксплуатации

Страница: 21 / 90

www.modelflight.com.au – World’s best source of JR products
Flaperon Wing Type Selection
Flaperons allow you to use the existing
ailerons as flaps. The ailerons can be
raised or lowered in unison as flaps, yet
still remain fully operational as the
ailerons of your RC airplane.
Connect this servo
to the AUX1 port of
the receiver Connect this servo
to the aileron port
of the receiver
Accessing and Utilizing the Flaperon Wing Type Selection
1. While the
D o w n
and
Select
buttons
are pressed, move the power switch
to the On position to access the
System mode.
2. Press either the
U p
or
D o w n
keys until
WING TYPE appears in the upper area
of the LCD.
3. Press either the (+) or (-) key to
turn on the Flaperon (FLPR)
Wing Type Selection.
Note : For Flaperon, one servo must be
used for each aileron control
surface.
4. Plug the left wing aileron servo into
the Auxiliary 1 (AUX 1) port of your
JR receiver. Connect the right aileron
servo into the aileron port (AILE) of
your receiver.
5. Check to make sure that the wing
servos move in the proper direction. For
a right turn, the right aileron should raise
while the left aileron lowers
simultaneously. For a left turn, the
opposite is true; the left aileron should
rise while the right aileron drops. If
your servos are not moving in the
direction just described, use the
Servo Reversing function to reverse the
travel direction of the servo(s) that are
moving improperly. Refer to the Servo
Reversing section for information on how
to reverse the travel direction.
Note : Each
servo's travel direction is
adjusted individually through the
Servo Reversing function.
Once the servos achieve their proper
travel direction, adjust their travel
amount, dual rates, sub-trim and
aileron differential.
Note : The applicable channel's left or
right travel adjustment may be made
individually by accessing the Travel
Adjust function. Refer to the Travel
Adjust section of this manual for
more information. The fine
adjustments of your aileron controls
should be made in the Dual-Rate
function. Refer to the Dual-Rate
section for information on how to
do so. You can also adjust the
neutral point of your aileron servos
individually through the use of
the Sub-Trim function. Refer to the
Sub-Trim section of this manual
for more information.
6. The flap lever located on the left
face of the transmitter controls the
aileron movements as flaps. To turn
off flaps go to the
Flap System
function on page 39 and reduce
the flap value to 0%.
Note : Differential is offered for the
Flaperon function of your XP6102.
For more information, please
refer to the Differential section of
this manual.
8. Press the
D o w n
key to access the
SWITCH SEL function.
9. Press the
U p
key to access the
MODEL SEL function.
10. Exit the WING TYPE function
by pressing the
D o w n
and
Select
keys simultaneously.
XP6102 - Airplane Manual 21