SECTION 4 - MACHINE OPERATION
4-18
3121783
Retracting The Outriggers
(Reference Figure 4-6. on page 4-21 for item number location)
Either
- Press and hold button no. 1
(item
1)
of the remote control.
The 4 outriggers will all retract at the same
time and lower the machine.
or
Operate each outrigger separately by
pressing button 2
(item 2)
to select which
outrigger to control
(each outrigger is num-
bered 1 thru 4, see decal at each outrigger,
each press of button 2 displays the outrigger
selected on the LCD display)
. Press button 1
(item 1)
to retract that outrigger.
Note:
To cycle back to outrigger auto-
retract mode, press button 2 (item 2) until
the LCD display shows the normal operat-
ing icons.
4.7
BOOM/PLATFORM OPERATION
THE BOOM WILL NOT OPERATE UNTIL THE OUTRIGGERS ARE PROPERLY SET
AND MACHINE IS LEVELED.
AT PLATFORM/REMOTE CONTROL STATION, TWIST EMERGENCY STOP BUT-
TON CLOCKWISE TO THE OUT POSITION, START ENGINE, AND ACTIVATE
FOOTSWITCH FOR ALL PLATFORM/ REMOTE CONTROL FUNCTIONS.
ALWAYS STOW (RAISE) THE LADDER AFTER ENTERING OR EXITING THE PLAT-
FORM TO PREVENT IT BEING DAMAGED WHEN OPERATING THE MACHINE.
If the operator attempts to raise the JIB with more than the
allowed capacity in the platform a maximum weight
reminder icon appears in the middle of the platform LCD dis-
play and the function stops.
If the machine is set up on outriggers for the reduced oper-
ating area, the swing function will be stopped if and when
you try to go outside the allowed working area. A message
on the platform LCD display will appear informing that it is
necessary to swing in the opposite direction to continue
operation.
NOTE:
At low temperatures start the motor and let it run for a
few minutes, so that the hydraulic oil circulates and
reaches at least 50°F (10°C) before operating the plat-
form.
AUTO
1
MANUAL
SELECT
2
To
order
go
to
Discount-Equipment.com
