SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
3121783
6-15
Rubber Track Maintenance/Replacement
Check track tension
Stop the machine on a firm, level, and uniform surface. Raise
the machine off the surface using the outriggers. Measure
distance A from the bottom of the roller to the inside of the
rubber belt. The rubber track tension is to be between 0.4 in
(10 mm) and 0.6 in (15 mm).
NOTE:
If the track is out of tolerance immediately discontinue
use of the machine
THE GREASE CONTAINED WITHIN THE HYDRAULIC TRACK IS PRESSURIZED.
NEVER LOOSEN GREASING VALVE 1 MORE THAN ONE (1) TURN. NEVER
LOOSEN GREASE VALVE 2.
1.
Ensure all debris has been removed between the
wheel teeth and track links.
2.
Remove the screws from the adjustment access lid
3.
3.
Loosening of the track.
4.
Slowly unscrew valve 1 in the counterclockwise
direction. Do not exceed one (1) screw rotation.
5.
If the grease does not begin to drain, slowly rotate
the track.
6.
Once correct track tension has been achieved, turn
grease valve 1 clockwise to tighten valve.
7.
Clean area of all trace grease.
A
3
1
2
PERICOLO
DANGER
To
order
go
to
Discount-Equipment.com
