JLG TOUCAN DUO, Руководство по обслуживанию

Страница: 39 / 108

39
TOUCAN Duo
Updated 06-2015
Models
ADJUSTMENTS IV-4 IV-4
4.4 Shelf alignment setting
Shelf alignment and transversal play setting
between the platform and the shelf must be
performed by a trained and qualified
personnel.
The shelf longitudinal alignment is performed by 4
bearings fixed on the shelf. This alignement is factory
preset and cannot be modified.
The shelf transversal alignment is performed by 4 slide
blocks fixed on the shelf. Each of them is equiped
with a setting screw to adjust the transversal play .
1- Clean the inside of the platform guide rails to
remove the used grease.
2- Loosen the locknuts of the slide blocks setting
screws.
3- Screw / unscrew the setting screws of each 4
blocks in order to center the shelf in the platform
and limit the transversal play at most.
Setting screw
Block
Locknut
Block
Bearing
As the block comes in contact with the "U"
profile of the platform, stop tighten the setting
screw.
4- Tighten the setting screws locknuts.
Torque value : 21 Nm approximatly.
Verification after setting :
Raise or lower the shelf two or three times (complete
stroke) with the nominal load distributed on the shelf.
- If no pinch occurs, the setting is correct.
- If a pinch occurs while rising or lowering, slightly
loosen the blocks setting screws.
- Check the torque of all setting screws locknuts.
Do not hesitate to contact you JLG France authorized
distributor for further information.
DANGER
! CAUTION