Jet JTS-315LA, Руководство по эксплуатации

Страница: 98 / 141

Test Report No.: No.: 17706687 001
Part II of II
Page 58 of 63
EN 61029-2-1:2012
Clause Requirement

Test Result - Remark Verdict
18.1.104.2 At maximum depth of cut for the maximum
diameter saw blade for which the tool is
designed the slot in the table surface shall
comply with the dimensions shown in Figure
Z110. The area surrounding the saw blade
where it passes through the table shall be of
material that can be easily cut such as plastic,
wood or light-alloy. This may be a replaceable
insert. d=12mm
The area surrounding the
saw blade where it passes
through the table is of
plastic.
P
18.1.104.Z1
When the machine is designed for bevel cutting
the adjustment shall be performed by tilting the
saw blade and not by tilting the table.
Adjustment is performed by
tilting the saw blade.
P
18.1.105 Rip fence See below
P
18.1.105.1 Circular saws shall be provided with a rip fence. Rip fence provided
P
The minimum height of the working surface of
the rip fence shall be 50 mm or the maximum
depth of cut whichever is the smaller. 60mm
P
18.1.105.2 The workpiece guiding part of the rip fence shall
be adjustable parallel with the saw blade so that
its out-feed end can be positioned forward to a
point in line with the front edge of the riving knife,
and rearwards to a point at the table level which
is in line with the first cutting tooth of the largest
saw blade for which the tool is designed when
adjusted to the maximum cutting depth. Checked and found
satisfactory
P
Material of the guiding surface, which may come
in contact with the blade, shall be made from
aluminum, plastic or wood. Made of aluminum.
P
The rip fence shall be provided with two guiding
surfaces, one for large cutting depths and one
for small cutting depths, so that the saw blade
cannot come in contact with the fence when the
saw blade is tilted for 45
0
. The height of the
lower guiding surface shall be not more than 12
mm (See also Figure Z112).
Two guiding surfaces are
provided. The lower guiding
surface is 11.8mm.
P
18.1.105.Z1 Cross-cutting fence See below
P
The saw may be provided with a cross-cutting
fence. The fixing arrangement shall ensure that
the fence cannot rise or swing out of position. For TS-315A, TS-315AE,
TS-315E, the rip fence can
be used as cross-cutting
fence, for other models
P