Jet JTS-315LA, Руководство по эксплуатации

Страница: 70 / 141

Test Report No.: No.: 17706687 001
Part II of II
Page 30 of 63
EN 61029-1:2009+A11
Clause Requirement

Test Result - Remark Verdict
Adjustment of guard P
For fixed guards that are to be removed at the
place of use as part of the routine maintenance
procedure, as described in the instruction manual,
the fastenings shall remain attached to the guard
or the tool N/A
Replacement of brushes is not considered as part
of the routine maintenance.
Considered
N/A
Hazardous by adjustment of guard P
Working elements and attachments for the tool P
Accessibility of dangerous moving parts through
dust collection openings The test probe specified in part
2 can not touch any dangerous
moving parts. Checked and
found satisfactory. P
18.2 Tools without fixing to the floor The machine must be fixed to
floor. N/A
With appliance inlet .................................................. : N/A
With doors ................................................................ : N/A
Intended to be filled-in with liquid ............................. : N/A
18.3 Tools shall have adequate stability when used
under the most onerous conditions of normal use
following the manufacturer's instruction.
Compliance is checked by the tests of the relevant
Part 2.
Tools provided with wheels shall have adequate
stability during transportation.
Compliance is checked by the following test.
The tool is held in its normal transportation position
while on a plane inclined at an angle of 10º to the
horizontal, the cable or cord wrapped up and
stored.
Tools intended to be filled with liquid by the user in
normal use are tested empty or filled with the most
unfavourable quantity of water or the
recommended liquid, up to the rated capacity.
While the tool is rotated slowly through 360°, it shall
not tip over.
Test performed and found
satisfactory.
See part 2.
Checked ok
Checked ok
Not intended to be filled with
liquid.
It did not tip over
P
18.4 Sharp edges, burrs, flashes and the like Checked by visual inspection,
found satisfactory. P
19 MECHANICAL STRENGTH P