![Jeep 2020 RENEGADE Скачать руководство пользователя страница 97](http://html1.mh-extra.com/html/jeep/2020-renegade/2020-renegade_owners-manual_4001898097.webp)
GETTING TO KNOW YOUR INSTRUMENT PANEL
95
Immobilizer Fail / VPS Electrical Alarm
Indicator Light
This telltale will illuminate when the
vehicle security alarm system has
detected an attempt to break into the
vehicle.
NOTE:
After cycling the ignition to the ON/RUN posi
-
tion, the Vehicle Security Warning Light could
illuminate if a problem with the system is
detected. This condition will result in the engine
being shut off after two seconds.
Service 4WD Warning Light — If Equipped
This warning light will illuminate to
signal a fault with the 4WD system. If
the light stays on or comes on during
driving, it means that the 4WD system
is not functioning properly and that service is
required. We recommend you drive to the
nearest service center and have the vehicle
serviced immediately.
White Indicator Lights
Hill Descent Control (HDC) Indicator Light — If
Equipped
This indicator shows when the Hill
Descent Control (HDC) feature is
turned on. The lamp will be on solid
when HDC is armed. HDC can only be
armed when the transfer case is in the “4WD
LOW” position and the vehicle speed is less
then 30 mph (48 km/h). If these conditions are
not met while attempting to use the HDC
feature, the HDC indicator light will flash on/off.
Light Sensor Failure
This light illuminates when there is
light sensor failure. If this light
illuminates, have an authorized
dealer inspect it.
Speed Warning Indicator Light — If Equipped
When Set Speed Warning is turned
on, the speed warning telltale will
illuminate in the instrument cluster
with a number matching the set
speed. When the set speed is exceeded, a
single chime will sound along with pop up
message of “Speed Warning Exceeded.” Speed
Warning can be turned on and off in the
instrument cluster display, for further
nformation refer to “Instrument Cluster Display
Menu Items” in “Getting To Know Your
nstrument Panel.”
Blue Indicator Lights
High Beam Indicator Light
This indicator light will illuminate to
indicate that the high beam
headlights are on. With the low beams
activated, push the multifunction
lever forward (toward the front of the vehicle) to
turn on the high beams. Pull the multifunction
lever rearward (toward the rear of the vehicle) to
turn off the high beams. If the high beams are
off, pull the lever toward you for a temporary
high beam on, “flash to pass” scenario.
3
20_BV_OM_EN_USC_t.book Page 95
Содержание 2020 RENEGADE
Страница 482: ......