Jeep 2020 RENEGADE, Руководство пользователя

Страница: 237 / 484

STARTING AND OPERATING 235
Off-Road Driving Tips
When To Use 4WD LOW Range
When off-road driving, shift to 4WD LOW for
additional traction and control on slippery or
difficult terrain, ascending or descending steep
hills, and to increase low-speed pulling power
(refer to “Four Wheel Drive” in this section for
further details). This range should be limited to
extreme situations such as deep snow, mud, or
sand where additional low speed pulling power
is needed. Vehicle speeds in excess of 25 mph
(40 km/h) should be avoided when in 4WD LOW
range.
Driving Through Water
Although your vehicle is capable of driving
through water, there are a number of
precautions that must be considered before
entering the water:
Driving through water more than a few inches/
centimeters deep will require extra caution to
ensure safety and prevent damage to your
vehicle. If you must drive through water, try to
determine the depth and the bottom condition
(and location of any obstacles) prior to entering.
Proceed with caution and maintain a steady
controlled speed less than 5 mph (8 km/h) in
deep water to minimize wave effects.
Flowing Water
If the water is swift flowing and rising (as in
storm run-off) avoid crossing until the water
level recedes and/or the flow rate is reduced. If
you must cross flowing-water, avoid depths in
excess of 9 inches (22 cm). The flowing water
can erode the streambed causing your vehicle
to sink into deeper water. Determine exit
point(s) that are downstream of your entry point
to allow for drifting.
Standing Water — Trailhawk Only
Avoid driving in standing water deeper than
19 inches (48 cm), and reduce speed
appropriately to minimize wave effects.
Maximum speed in 19 inches (48 cm) of water
is less than 5 mph (8 km/h).
Maintenance
After driving through deep water, inspect your
vehicle fluids and lubricants (engine,
transmission, Power Transfer Unit and Rear
Drive Module) to ensure they have not been
contaminated. Contaminated fluids and
lubricants (milky, foamy in appearance) should
be flushed/changed as soon as possible to
prevent component damage.
Driving In Snow, Mud And Sand
In heavy snow, when pulling a load, or for
additional control at slower speeds, shift the
transmission to a low gear and shift the 4WD
system to the appropriate terrain mode, using
4WD LOW if necessary. Refer to “Four Wheel
Drive” in “Starting And Operating” for further
information. Do not shift to a lower gear than
necessary to maintain headway. Over-revving
the engine can spin the wheels and traction will
be lost.
Avoid abrupt downshifts on icy or slippery roads
because engine braking may cause skidding
and loss of control.
CAUTION!
When driving through water, do not exceed
5 mph (8 km/h). Always check water depth
before entering as a precaution, and check all
fluids afterward. Driving through water may
cause damage that may not be covered by
the New Vehicle Limited Warranty.
5
20_BV_OM_EN_USC_t.book Page 235