Jeep 2020 RENEGADE, Руководство пользователя

Страница: 110 / 484

108 SAFETY
The BSM detection zone covers approximately
one lane width on both sides of the vehicle,
10 ft (3 m). The zone length starts at the
outside mirror and extends approximately 20 ft
(6 m) beyond the rear bumper of the vehicle.
The BSM system monitors the detection zones
on both sides of the vehicle when the vehicle
speed reaches approximately 6 mph (10 km/h)
or higher and will alert the driver of vehicles in
these areas.
NOTE:

The BSM system does NOT alert the driver
about rapidly approaching vehicles that are
outside the detection zones.

If a trailer is connected to the vehicle, it is
necessary to deactivate the BSM system
manually through the settings menu to avoid
a misdetection. Refer to “Uconnect Settings”
in “Multimedia” for further information.
The area on the rear fascia where the radar
sensors are located must remain free of snow,
ice, and dirt/road contamination so that the
BSM system can function properly. Do not block
the radar sensors located on the rear fascia
with foreign objects (bumper stickers, bicycle
racks, etc.).
Rear Sensor Locations
The BSM system notifies the driver of objects in
the detection zones by illuminating the BSM
warning light located in the outside mirrors in
addition to sounding an audible (chime) alert
and reducing the radio volume. Refer to “Modes
Of Operation” in this section for further
information.
BSM Warning Light
The BSM system monitors the detection zone
from three different entry points (side, rear,
front) while driving to see if an alert is
necessary. The BSM system will issue an alert
during these types of zone entries.
Entering From The Side
Vehicles that move into your adjacent lanes
from either side of the vehicle.
Side Monitoring
20_BV_OM_EN_USC_t.book Page 108