JEAN LUTZ TARALOG, Инструкция по эксплуатации

Страница: 58 / 158

58
Programming table - TARALOG version TG2TCT231EN
Names and numbers
of Menus
Names and numbers of
submenus
Comments
1 Sensors
Adjustments of different sensors : zero, full scales, etc.
11 Depth Depth encoder coefficient (pulse/m) and
positive / negative displacement (1/2)
12 Flow and volume Volume per pump stroke.
Stroke detection adjust (cl/pulse).
13 Rotation speed Number of bolts detected by the rotation
sensor (pulse/revolution)
14 Concrete pressure offset Volume per pump stroke.
15 Torque pressure offset Stroke detection adjustment (cl/pulse)
16 Torque unit and factor Unit and conversion factors for torque
calculation (bar or t.m)
If t.m : speed coefficient in Kg.m/bar
17 X angle offset Inclinometer zero correction X (mA)
(Standard value : 12 mA)
18 Y angle offset Inclinometer zero correction Y (mA)
(Standard value : 12 mA)
19 Traction pressure offset Traction sensor connection (mA) (option)
(Standard value : 4 mA)
1A Thrust pressure offset Thrust pressure sensor correction (mA)
(option)
(Standard value : 4 mA)
2 MEMOBLOC
Adjust the parameters of the numerical registration on the MEMOBLOC
21 Digital Selection Recording of data in MEMOBLOC (yes/no)
22 Recording step Recording step adjustment in cm
Standard value : 8 cm
23 "MEMOLEC" mode MEMOBLOC access by PC
3 Time and Date
To set TARALOG's internal time and date
31 Adjustments Modification if necessary.
4 Configuration…
Information which will be displayed on the screen and formatting.
41 Depth, Overbr. Profile
range Maximum depth on the screen (m)
42 Graphic scale Graphic scales in drilling mode.
Graphic scales in concreting mode.
43 Horizontal, overbr. bar Overconsumption instruction : tolerances
around the instruction which allow to place the
cursor and full scale of the bargraph.