JCM Taiko Series, Руководство по эксплуатации и обслуживанию

Страница: 42 / 86

P/N 960-100175R_Rev. 6 {EDP #200824} © 2016, JAPAN CASH MACHINE CO., LTD.
4 - 4
Section 4 Taiko™ Series Banknote Acceptor Disassembly/Reassembly
Encoder Board and Drive Motor
Removal
To remove the Transport Drum Encoder Circuit
Board and Drive Motor Assembly, proceed as fol-
lows:
1. Remove the single (1) Mounting Screw (Figure 4-
13 a ) from the Lower Center Guide (Figure 4-13
b ).
2. Remove the Motor Drive Assembly (Figure 4-13
c ) from the Lower Center Guide.
3. Remove the single (1) Mounting Screw (Figure 4-
14 a ) retaining the Encoder Circuit Board (Figure
4-14 b ), and take the Encoder Circuit Board off
the Motor Drive Assembly (Figure 4-14 c ).
Entrance and Exit Solenoid
Removal
To remove the Transport Entrance and Exit Sole-
noid Units, proceed as follows:
1. Remove the Lower Guide Assembly (Figure 4-15
a ) by pressing the Lower Guide Locks (Figure 4-
15 b
1
& b
2
) in the direction indicated by the small
arrows.
2. Remove the two (2) Mounting Screws (Figure 4-
16 a
1
& a
2
) from the Unit and remove the Rear
Guide Assembly (Figure 4-16 b ).
Figure 4-13 Motor Drive Assembly Removal
a
b
c
Figure 4-13 Motor Drive Assembly Removal
Figure 4-14 Encoder Circuit Board Removal
a
b
c
Figure 4-14 Encoder Circuit Board Removal
Figure 4-15 Lower Guide Assembly Removal
a
b
2
b
1
Figure 4-15 Lower Guide Assembly Removal
Figure 4-16 Lower Guide Assembly Removal
b
a
2
a
1
c
2
c
1
Figure 4-16 Lower Guide Assembly Removal
NOTE: Be careful that the two (2)
bushings (Figure 4-16 c
1
& c
2
)
located on the left and right sides of
the Rear Guide Assembly are not
lost when removing the assembly.