Page 1
Validator Update Instructions for Rowe BC1200 $1 - $5
Kit Overview
The purpose of the kit is to replace the Rowe BA50 transport and stacker with a 120-volt
Mars validator with a compact mask.
The kit and these instructions pertain to a Rowe
BC1200; this is a front-loading changer with two hoppers.
There are two variations of the kit;
one will process $1-$5 and the second $1-$20. This kit is designed for dollar bill changers
that are not used to make change for a coin.
The installation information is intended for experienced personnel familiar with the operation
of these components. All of the installation procedures must be reviewed and understood
prior to installing the kit. The installation instructions are based upon a dollar bill changer
that has not been modified from the original factory configuration. If the machine has been
altered in any way, restore the machine to the original factory configuration prior to
beginning the conversion.
Kit Components
The kit contains the following parts:
Module in black plastic box;
labeled BC1200/1400/3500
Metal validator slide plate with wide opening – short style
Jumper with 15 position connector
Package of Velcro
Additional Required Items Not Included With Kit
Working Mars validator – Model AE2411/AE2451, VN2511, or AE2611
The four 11-32 hex nuts used to mount the Mars validator to the validator slide plate are
included in the Mars validator shipping box.
Dollar bills to test the validator and verify operation of the kit
Electrical tape
Tools Required
11/32”, ¼”, and 3/8” long handle nut drivers
Pliers
Installation Instructions
1.
Unplug the power cord from the wall and open the door of the changer.
2.
Remove the BA50 bill transport by unplugging the harness at the 15-position harness
connector (3 x 5). A 12-inch harness will still be connected to the side of the BA50
transport.
3.
Connect the jumper supplied with the kit to the now open 15-position connector of the
machines wiring harness.
4.
Remove the bill box(es) from the stacker assembly.
5.
Remove the stacker assembly by unscrewing the two ¼”screws at the top of the
assembly. It may be necessary to hold the nuts under the assembly with a pair of
pliers. [For changers with a dual stacker: remove the two ¼” screws that secure the
stacker assembly base to the bill box bracket. The bill box bracket can remain in the
changer] Disconnect the harness from the upper rear right hand side. Slide the stacker
assembly forward out of the changer. Replace the upper two screws and nuts. The
original stacker harness will not be connected to any component.
