JCM Taiko Series, Руководство по эксплуатации и обслуживанию

Страница: 53 / 86

P/N 960-100175R_Rev. 6 {EDP #200824} © 2016, JAPAN CASH MACHINE CO., LTD.
6 - 5
Calibration and Testing Taiko™ Series Banknote Acceptor Section 6
Calibration Procedure
Calibration Description
Calibration sets a starting reference point for all
Optical and Magnetic Sensors within the Taiko™
Unit.
Calibration Tool Requirements
The equipment and tools listed below are required
to perform Taiko™ Workbench calibration.
•
Taiko Unit (PUB-7/11)
•
JCM Power Supply
•
Taiko Harness A
•
Download Application
•
KS-088 Reference Paper (
with Bar Code Reader
)
When to Calibrate
–
After new software has been downloaded
–
After a Banknote Acceptor component has
been disassembled/reassembled for repair
–
After the CPU and/or Sensor Circuit Board
has been replaced.
Initial Settings
1. Make sure power is not supplied to the Taiko™
Unit intended for calibration, and remove it from
its Bezel mounting (Figure 6-6).
2. Connect an External Power Supply. (Figure 6-3
and Figure 6-5).
3. Set Right Side Panel DIP Switches No. 1, 2 and 8
ON
(Figure 6-7), and apply AC power to the
External DC Power Supply Unit.
4. Confirm that the Front Panel LED is flashing a
White Light.
5. Set DIP Switch No.1 to ‘
OFF
’ and confirm that
the Green Front Panel LED is lit (ON).
6. Insert the KS-070 Reference Paper into the
Taiko™ Unit (Figure 6-8 a ), or if calibration of
the Barcode Coupon Specification Unit is
required, insert the KS-088 Reference Paper.
When the Rollers begin to rotate, continue insert-
ing the Reference Paper all the way into the Unit
(Figure 6-8 b ).
7. When the Reference Paper reaches the inner
limit, the Front Panel LED will flash a Green
Color.
8. Turn DIP Switch No.8 ‘
OFF
’ to begin the Cali-
bration Procedure.
9. Confirm that the Front Panel Yellow LED is lit,
indicating a Sensor Adjustment is occurring.
10. When the Paper adjustment is complete, the
Reference Paper will exit out of the Taiko™ Unit
automatically (Figure 6-9).
11. Remove the KS-070 or KS-088 Reference Paper.
The Front Panel LED will flash Green .
12. Turn DIP Switch No.8 ‘
ON
’ to begin the Non-
Paper Calibration Procedure.
13. When the Non-Paper Adjustment and EEPROM
data writing procedures are complete, confirm
that the Front Panel LED is lit a Blue Color.
NOTE: This task should only be
accomplished at a Workbench.
NOTE: See Figure A-1 on page A-5 to
identify each maintenance part number to
order.
Figure 6-6 Removing Taiko from Bezel Mount
Figure 6-6 Removing Taiko from Bezel Mount
Figure 6-7 Adjustment DIP Switch Setting
Figure 6-7 Adjustment DIP Switch Setting
ON
Figure 6-8 Reference Paper Insertion
Figure 6-8 Reference Paper Insertion
a
b
KS-070 or KS-088
Figure 6-9 Adjustment Complete Paper Ejec-
tion
Figure 6-9 Adjustment Complete Paper Ejection
WARNING: If the adjustments and/or
EEPROM Data writing procedures are
not successfully completed, the
Red
LED will light! In this case, start the
procedure over again from the very
beginning.