JCM Taiko Series, Руководство по эксплуатации и обслуживанию

Страница: 22 / 86

P/N 960-100175R_Rev. 6 {EDP #200824} © 2016, JAPAN CASH MACHINE CO., LTD.
2 - 2
Section 2 Taiko™ Series Banknote Acceptor Installation
9. Open the Upper Guide by pressing-in and holding
down the Upper Guide Open/Close Buttons while
lifting the Lid up (Figure 2-6 j).
10. Insert the Bezel Installation Guide Pin into the
Bezel Guide (Figure 2-6 k).
11. Slide the Guide all the way in and push down on
the Taiko™ Unit body (Figure 2-6 l).
12. Close the Upper Guide firmly until a locking
Click is heard (Figure 2-7).
Power Harness Wiring Procedure
Before beginning to build a Power Interface
Connector, ensure one of the two plug types listed
in Table 2-1 are available.
Once the Power Interface Connector Plug has been
fastened to the Power/Signal Cable being used,
perform the following steps:
1. Confirm that power is NOT supplied to the new
Power Harness.
2. Insert the new Power Harness Socket into the
right side Panel Interface Connector of the
Taiko™ Unit Body (Figure 2-8).
3. Supply power and confirm that the Taiko™ Unit
operates properly.
Clearing a Banknote Jam
Clearing an Upper Area Banknote Jam
When an upper area Banknote jam occurs, the
Front Panel Red LED Display will begin flashing
three (3) times with a pause between flash sets.
Perform the following steps to clear a Banknote
jam within the Taiko™ Unit’s Acceptor area:
1. Remove Power from the Taiko™ Unit.
Figure 2-5 Mounting the Taiko Bezel
Figure 2-5 Mounting the Taiko Bezel
Bezel Brackets
Hexagonal
Nuts
Figure 2-6 Installing the Taiko Bezel
Figure 2-6 Installing the Taiko Bezel
j
k
l
PIN
Figure 2-7 Closing the Taiko Upper Guide
Figure 2-7 Closing the Taiko Upper Guide
Click
Caution: Ensure that the Taiko Unit body
and Bezel are firmly installed and
securely fixed to the door before closing
the Upper Guide; When closing the
Upper Guide, be careful not to get your
finger caught under the lid when closing
it.
NOTE: When removing a Taiko Unit, perform the
previously described procedure in reverse.
Table 2-1 Power Connector Specifications
Part
Connector
Lock Lever Socket Ribbon Cable Socket
Plug
XG5M-1032-N
(Omron)
XG4M-1030-T
(Omron)
Semi-Cover XG5X-0501 (Omron) N/A
Lock Lever 2 XG4Z-0002 (Omron) N/A
Applicable
Wire Size
UL1061 WAG24
1.27mm Pitch Flat
Ribbon Cable, AWG28
UL2651 or UL20012
Figure 2-8 Attaching a Taiko Power
Connector
Figure 2-8 Attaching a Taiko Power Connector
WARNING: When installing a Taiko Unit,
or connecting its Harness Plug, be sure
power to the harness is disconnected.
The Taiko Unit is only designed to use a
12 or 24 Volt DC input. Any other power
level can damage the Taiko Unit!
If the power Harness itself is strongly
pulled on, it may tear loose from its
Connector’s Pins.