Routine Maintenance
Transmission
155
155
9811/5700-7
Oil Immersed Brakes
The axle oil is used to lubricate the brake components, and
to cool the brake plates.
It is important that the oil is changed regularly as specified
in the service schedule - the lubricating properties of the oil
will reduce as a result of brake wear.
Consult your JCB Distributor for advice if necessary.
Checking the Hub Oil Levels
T3-011_2
Check each hub separately.
1
Park the machine on level ground with the OIL LEVEL
mark horizontal. There is a tolerance of 5 mm (0.2 in)
above or below the horizontal.
2
Engage the park brake. Set the transmission to
neutral. Lower the attachments to the ground. Stop
the engine and remove the starter key.
3
Clean the area around the fill/level plug
121-C
.
Remove the plug. Oil should be level with the bottom
of the hole. If necessary, add the recommended oil.
Clean the plug before refitting it.
Fig 121.
Changing the Hub Oil
Change the oil in each hub separately
1
Set the machine level, with the wheels just clear of the
ground. Manually rotate the wheels to bring the OIL
LEVEL mark on the hubs to the vertical position, with
the fill/level plugs
122-C
at the bottom.
2
Drain the oil:
a
Place a container of suitable size beneath plug
122-C
to catch the oil.
!M
CAUTION
Oil will gush from the hole when the drain plug is
removed. Keep to one side when you remove the plug.
2-3-4-2
b
Remove fill/level plugs
122-C
. Allow time for the
oil to drain out.
3
Set OIL LEVEL marks to the horizontal.
a
Fill the hubs with recommended axle oil, through
the fill/level holes
122-C
. Oil should be level with
the bottom of the fill/level hole.
b
Clean and refit fill/level plugs
122-C
.
Fig 122.
Содержание RTFL 926
