71 - 2
Removal and Replacement
Stabiliser Controls
The stabiliser controls
A
and associated cables are housed
in the R.H. side console as shown.
There are two control cables which operate the R.H. and
L.H. stabiliser control valves on the excavator valve block.
Note the routing of the existing cables and route the new
cable(s) in the same way.
Removal
1
Park the machine on firm level ground, apply the
parking brake. Lower the loader arms and excavator to
the ground, switch OFF the engine and remove the
starter key.
2
Working under the machine at the excavator valve,
undo the locknut
B
. Remove the screws
C
and slide
back the housing
D
to reveal the clevis as shown.
Remove the clevis pin
E
to release the cable from the
spool.
3
Feed the end of the cable back underneath the cab to
the rear wheel arch on the R.H. side of the machine and
release the cable from the clamp assembly at position
X
as shown.
4
Working in the cab, remove the fixings
F
from around
the base of the control levers and carefully withdraw the
lever assembly from the side console to reveal the
cables connected on the underside.
5
Remove the clamp
G
securing the cables to the
bracket. Remove the spring clip and clevis pin
H
to
release the cable.
6
From inside the side console, carefully pull the cable up
into the cab through the aperture in the cab floor.
Replacement
Replacement is the reverse of the removal sequence.
After fitting the cable(s), operate the controls and check that
the stabilisers function correctly.
Section D
9803/3280
Section D
71 - 2
Issue 1
Control Cables
A394410
A
A405180
X
