JBT Fresh'n Squeeze Series, Руководство по обслуживанию

Страница: 28 / 96

28
FNS-0014-060-EN June 2019 Rev A
Troubleshooting
•
Juicer will not turn on
1. Juicer is not plugged into electrical outlet.
2. Building circuit breaker or GFI has tripped (reset).
3. Loose wire connection.
Check that all electrical connections are properly installed and secured.
4. On/Off power switch is disconnected
a. Unplug the juicer.
b. With the Front door open loosen the four screws holding the electrical box closed.
c. On the backside of the lid insure that the two black wires (103 and 104) are connected to the
On/Off switch.
d. If power switch is broken replace lid of electrical box or the entire box.
•
Juicer starts, but shuts off
1. Juicer is tripping GFCI outlet
Certain GFCI outlets will not support the juicer. Have electrician replace with a compatible outlet.
Known compatible outlets include all models of Legrand 1597 for 15 Amp service and all models of
Legrand 2097 for 20 Amp service. Others may work as well
2. Building circuit breaker is not properly rated for 15 Amps.
3. Extension cord or wiring is too long.
Shorten extension cord or use heavier gauge wire. (See Page 6 "Electrical Specifications")
4. All covers not completely closed (including cart).
Juicer may be flexing when squeezing fruit, causing switch to open. Make sure all latches are
completely locked.
5. The hopper and door cables are reversed.
a. Unplug juicer.
b. Remove the hopper access panel.
c. Unplug the hopper and front door cables (two smaller connectors on top and farthest from
access panel).
d. Switch the cables and plug them back in.
• Juicer will not start
1. Covers are not completely closed.
Open and close both doors, make sure the sensors are securely fastened and then ensure the
doors are firmly closed.
2. Safety sensor has failed. Refer to checking safety sensors to identify broken safety sensor
and replace as necessary.
3. Loose wire inside electrical box