JBT Fresh'n Squeeze Series, Руководство по обслуживанию

Страница: 92 / 96

92
FNS-0014-060-EN June 2019 Rev A
5. Be careful when removing the black wires on the overload. If possible, hold the overload
itself and rock the connector back and forth to remove the black wires. Refer to Figure 80.
Figure 80. Disconnect Overload Connections
6. Place the lid on a clean flat surface with the touch screen facing down, make sure there is
nothing that will scratch or harm the screen. Setting on a clean cloth is preferable.
7. Locate the two green wire terminal strips on the PLC (large black device on the inside of the
lid) and detach both of them. May need to use a flat head screwdriver to gently pry them out
(wires can be left connected to the wire clamps). Refer to Figure 81.
Figure 81. Detach Terminal Strips
Use a phillips head screwdriver to remove the four screws located in the corners of the PLC
cover. Do not remove the screws that come off the sides of the PLC. Refer to Figure 82.
Figure 82. Location of PLC Cover Screws (4)