29
FNS-0014-060-EN June 2019 Rev A
Troubleshooting (continued)
•
Safety Circuit Fault screen will not go away
1. Safety sensors are not connected properly.
a. Turn off Juicer and unplug from outlet.
b. Remove the hopper access panel.
c. Insure that all the cables on the back of the electrical box are installed and the twist locks on
the connectors are tight.
2. A safety sensor has failed.
a. Follow procedures for checking safety circuits in the “Electrical Drawings and Procedures”
section of this manual.
b. If Faulty sensor is found, replace safety sensor and cable assembly.
3. Electrical box does not support safety circuit monitoring (Only perform these steps if
previous troubleshooting steps do not fix the problem, the process will disable this function
on the juicer)
a. Click in the bottom right corner of the fault screen.
b. Enter the password for accessing the service screen.
c. Enter the second service page.
d. Turn off the safety check.
NOTE:
This does not fix an issue, it just disables the screen. If performed on a juicer with this
feature, the juicer will not run. The issue must be fixed and the safety check needs to be turned
back on.
•
Juicer runs extremely slowly
1. Constant speed feature has been enabled.
a. Turn juicer off and back on to correct
2. Variable frequency drive programing has been changed
a. Refer to the procedure for re-programing the VFD in the “Electrical Drawings and Procedures”
section of this manual.
b. Follow procedure at the bottom for a Factory Reset
c. Return to the top and follow procedure to program the drive from the beginning
3. PLC terminal strip not firmly connected
a. Unplug the juicer
b. Loosen the four screws on the front of the electrical box
c. On the back side of the lid make sure the green strips connected to the PLC are fully seated
Содержание Fresh'n Squeeze Series
