JBT Fresh'n Squeeze Series, Руководство по обслуживанию

Страница: 95 / 96

95
FNS-0014-060-EN June 2019 Rev A
d. Gently push the board down until the green strip is resting on the housing. Refer to Figure 87
Figure 87. Gently Push Down on Board
11. Replace the back cover of the PLC.
12. Reinsert the four screws that were removed from cover. There are two different size screws
used, the short ones go to the lower end of the cover while the longer screws are on the
higher end, closest to the on and off switch. Refer to Figure 88.
Figure 88. PLC Cover Screws
13. Reattach both green wire terminal strips. Use the numbering system on the PLC to
insure the proper connections.
The terminal strip with 6 wires goes on the side with 0V over the 1 position and V+ over
the 15. The terminal strip with 9 or 10 wires (depending on model) goes on the side with
I0 under 15 and V+ under 1.
Refer to Figure 89.
Figure 89. Reattach Terminal Strips