Japan Radio Co. JMR-7230-S3, Инструкция по эксплуатации

Страница: 38 / 576

Section 19 Adjusting and Setting up Equipment (for Services) 19-26
The setting target can be checked with [Source Device] display, [Terminal] display and [Sensor]
display.
Perform the settings shown in the following table and then click on the [Set] button.
Setting Item Description of Setting Setting Value
Baud Rate Select the baud rate of the serial port on the
combo box.
In the [Detail] dialog of any of CH8 to CH10,
the [Baud Rate] addition ratio combo box is
displayed on the right side of the [Baud Rate]
combo box. Selectable baud rates vary
depending on the serial port
(refer to "Selectable baud
rates").
[Baud Rate] addition ratio
combo box Displayed in the [Detail] dialog of CH8 to
CH10. By using this combo box, the addition
ratio (%) for adjusting the baud rate can be
changed. The baud rate is determined by
adding the additional ratio to the value that is
set in the [Baud Rate] combo box.
Example) 4800 × (1 + 1.5 / 100) = 4872
Additional ratio
0.0% to 3.0% (can be set in
the unit of 0.5%)
Data Length Select the data length of the corresponding
serial port from the combo box. 5/6/7/8
Parity Select the parity of the corresponding serial
port from the combo box. None/Odd/Even
Stop Bits (Stop Bit Length) Select the stop bit length of the corresponding
serial port from the combo box. 1/2
Buffer Size Enter the buffer size of the corresponding
serial port from the list. 0 to 10240 byte
Time Out Enter the time-out duration of the
corresponding serial port from the list. 0 to 999s
Checksum Select the check box and enable the
checksum of the sentence of the
corresponding serial port. To enable: Select.
To disable: Clear.
Subsystem Set the equipment to be connected for Alert
Handling.
Displayed only when the sensor is "Alert (from
Subsystem) " or "Alert (to CAM) ".
The selection is also allowed for the
subsystem that has already been used in the
channel of some other serial port. "Alert (from Subsystem) ":
Equipment that is set as
-/installed (Task Station and
sensor)
"Alert (to CAM) ":
Equipment that is set as
-/installed (Task Station)
Primary/Secondary Select Primary or Secondary for IAS
(MODBUS) input.
Displayed only when the sensor is "IAS
(MODBUS) ".
Primary: Primary system
Secondary: Secondary
system