Japan Radio Co. JMR-7230-S3, Инструкция по эксплуатации

Страница: 35 / 576

19-23 Section 19 Adjusting and Setting up Equipment (for Services)
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
Setting Item Description of Setting Setting Value
Gyro 1. Select the check box and enable the serial port for the
Gyro.
2. Select a sensor to be connected to the serial port for
Gyro from the [Sensor] combo box. When not
selecting a sensor, set [ - ].
To enable: Select.
To disable: Clear.
LOG 1. Select the check box and enable the serial port for the
LOG.
2. Select a sensor to be connected to the serial port for
LOG from the [Sensor] combo box. When not
selecting a sensor, set [ - ].
To enable: Select.
To disable: Clear.
GPS 1. Select the check box and enable the serial port for the
GPS.
2. Select a sensor to be connected to the serial port for
the GPS from the [Sensor] combo box. When not
selecting a sensor, set [ - ].
To enable: Select.
To disable: Clear.
AIS 1. Select the check box and enable the serial port for the
AIS.
2. Select a sensor to be connected to the serial port for
the AIS from the [Sensor] combo box. When not
selecting a sensor, set [ - ].
To enable: Select.
To disable: Clear.
Table A: Sensors that can be selected by serial ports on CCU
Serial port Sensor name
Gyro Heading Sensor (NMEA) , Heading Sensor1 (NMEA) *1 , Heading Sensor2 (NMEA) *1
Heading Sensor (Gyro I/F) , Heading Sensor1 (Gyro I/F)
*1
, Heading Sensor2 (Gyro
I/F) *1
LOG Log (NMEA) , Log1 (NMEA) *2 , Log2 (NMEA) *2
Log (Gyro I/F)
*3
Selector
GPS GPS 1
GPS 2 *4
GPS 3
*4
GPS 4
*4
Selector
AIS AIS
*1: Only when two heading sensors are available
*2: Only when two logs are available
*3: Only when Heading Sensor (Gyro I/F) is selected for Gyro of CCU
*4: May not be displayed depending on the number of GPS units