Japan Radio Co. JMR-7230-S3, Инструкция по эксплуатации

Страница: 262 / 576

Section 24 Specifications 24-32
24.32 NKE-2632
、
NKE-2632-H
GENERAL SPECIFICATION NKE-2632
Dimension Height 720 × Swing Circle 2770 (mm)
Mass Approx. 85kg
Polarization Horizontal
Horizontal beam width:
2.7

Vertical beam width:
25

Side lobe level:
below -26dB (within

10

)
below -30dB (outside

10

)
Revolution Approx. 24 rpm
Power Supply for Motor
100 to 115VAC, 50/60Hz 1

or
220 to 240VAC, 50/60Hz 1

Maximum Wind Velocity 51.5m/s (100kt)
Transmitting Frequency
P0N(3035MHz), Q0N(3065

4MHz) or (3060

4MHz)
Transmission output
Peak-to-peak value 250W

50% (Average value 5.8W or lower)
Transmitting Tube Solid State Device
TX Pulse width (1st) /
(TX Pulse width, Frequency Deviation Width
(2nd)) / Repetition Frequency
(Observation Range)
SP1: 0.07 μ s/(4.6 μ s, 8MHz)/1860Hz or 2280Hz (0.125NM, 0.25NM,
0.5NM, 0.75NM, 1.5NM, 3NM)
MP1: 0.14 μ s/(9.1 μ s, 8MHz)/1860Hz or 2280Hz (0.75NM, 1.5NM, 3NM,
6NM)
MP2: 0.29 μ s/(9.1 μ s, 8MHz)/1860Hz or 2280Hz (1.5NM, 3NM, 6NM,
12NM)
LP1: 0.57 μ s/(9.1 μ s, 8MHz)/1280Hz (3NM, 6NM, 12NM, 24NM)
LP2: 1.14 μ s/(18.3 μ s, 8MHz)/640Hz (3NM, 6NM, 12NM, 24NM, 48NM,
96NM)
Duplexer Circ Diode Limiter
Frond End Module Built-in
Overall Noise Figure 4.0dB (typical)
Performance Monitor Built-in
Intermediate Frequency Amplifier
Intermediate Frequency 63MHz
Band Width 30MHz
Gain More than 28dB
Amplifying Characteristics Linear Amplifier
GENERAL SPECIFICATION NKE-2632-H
Dimension Height 720 × Swing Circle 2770 (mm)
Mass Approx. 90kg
Polarization Horizontal
Horizontal beam width:
2.7

Vertical beam width: 25

Side lobe level:
below -26dB (within

10

)
below -30dB (outside

10

)
Revolution Approx. 48 rpm
Power Supply for Motor
100 to 115VAC, 50/60Hz 1

or 220 to 240VAC, 50/60Hz 1

Maximum Wind Velocity 51.5m/s (100kt)
Transmitting Frequency
P0N(3035MHz), Q0N(3065

4MHz) or (3060

4MHz)
Transmission output
Peak-to-peak value 250W

50% (Average value 5.8W or lower)
Transmitting Tube Solid State Device
TX Pulse width (1st) /
(TX Pulse width, Frequency Deviation Width
(2nd)) / Repetition Frequency
(Observation Range)
SP1: 0.07 μ s/(4.6 μ s, 8MHz)/1860Hz or 2280Hz (0.125NM, 0.25NM,
0.5NM, 0.75NM, 1.5NM, 3NM)
MP1: 0.14 μ s/(9.1 μ s, 8MHz)/1860Hz or 2280Hz (0.75NM, 1.5NM, 3NM,
6NM)
MP2: 0.29 μ s/(9.1 μ s, 8MHz)/1860Hz or 2280Hz (1.5NM, 3NM, 6NM,
12NM)
LP1: 0.57 μ s/(9.1 μ s, 8MHz)/1280Hz (3NM, 6NM, 12NM, 24NM)
LP2: 1.14 μ s/(18.3 μ s, 8MHz)/640Hz (6NM, 12NM, 24NM, 48NM,
96NM)
Duplexer Circ Diode Limiter
Frond End Module Built-in
Overall Noise Figure 4.0dB (typical)
Performance Monitor Built-in
Intermediate Frequency Amplifier
Intermediate Frequency 63MHz
Band Width 30MHz
Gain More than 28dB
Amplifying Characteristics Linear Amplifier