janitza UMG 605 PRO, Руководство пользователя и технические данные

Страница: 40 / 87

UMG 605-PRO
www.janitza.de
35
10. Operation
In order to make it easier to install and
commission the device without a PC, it has
a display, as well as buttons 1, 2
and the Service button.
Important parameters such as the current
transformer and the device address are
listed in the parameter list in section “17.
Parameter list” and can be programmed
directly on the device.
When operating, the device differentiates
between:
• Display mode and
• Programming mode
10. 1 Button functions
Press the button for a short time:
• scroll forwards
• digit/value +1
Press the button for a long time:
• scroll backwards
• digit/value -1
Press and hold both buttons simultaneously
for around 1 second:
• Switch between display mode and
programming mode.
The device is operated using buttons 1 and 2.
The service button is only for use by trained
service employees.
Fig. Front view of UMG 605 -PRO control element
10. 2 Display mode
After the power returns, the device
is in display mode.
In display mode, you can use buttons 1
and 2 to scroll through the measured value
indications.
• Use button 1 to select the phase for the
measured values.
• Use button 2 to scroll between the
measured values for current, voltage,
power, etc.
The factory default setting for the measured
value indications is shown in section “17.
Parameter list”.
N L1
RxD TxD
V
L1 L2 L3 L4 Input Output
Fig. Display example for "Display mode". Measured value
indication U
L1-N
= 230.0 V.
Fig. Display example for rotation fi eld and frequency.
RxD TxD L1 L2 L3 L4 Input Output
Hz
C
NOTE!
You can reconfi gure the functions
of the buttons and the selection
of the values to be displayed using
the GridVis® software as a Jasic
program. (see www.janitza.de)