Jands ESP II 24, Руководство по эксплуатации

Страница: 12 / 53

12
Using Masters Controls
P1 and P2 Faders
The P1 Master Fader scales the top row of preset faders, likewise the P2
Master Fader scales the overall level of the bottom row of preset faders.
By moving the P1 fader up while moving the P2 fader down it’s possible
to crossfade between the settings on the 2 rows of channel preset faders.
Add / Solo Master Switch
The Flash buttons can be set to operate in 3 different ways or turned off
completely. To change the operation of the flash buttons press the Add /
Solo switch. With each press of the button the 2 leds within the switch
change to indicate which mode has been selected.
• Add - Indicated by the Green Led being on. Pressing a FLASH button
causes that output to flash instantly to the level set by the Flash
Master fader.
• Add Latch - Indicated by the Green Led Flashing. The Flash buttons
push-on and push-off instead of flashing. When a Flash button is
latched on, the Channel LED will flash synchronously with the Add /
Solo switch LED. If Add Latch is disabled while some channels are
Latched, the channels will unlatch but will not become latched again
if Add Latch is subsequently enabled.
• Solo - Indicated by the Red Led being on. Pressing a Flash button
causes that output to flash instantly to the level set by the Flash
Master fader, while at the same turning off all other desk output.
• Disabled - Indicated by neither Led being on. Pressing a channel
Flash button has NO effect.
Add / Solo Fader
This fader scales the intensity of the flash buttons.
Grand Master Fader
Scales the intensity of all console outputs except the flash buttons.
D.B.O. Switch
This button performs two functions:
1
Blackout. Press to black out the output of the console. The button can
be set to momentary or latching operation.
2 Inhibit. To prevent a channel from appearing in any output, hold a
channel Flash button down and press the DBO button.