JAI VISCAM 1000 System, Руководство по установке

Страница: 21 / 60

System Set-Up 15
VISCAM 1000 Systems
4.3 Connect the Setup Computer to the Camera
•
Position the setup computer next to the camera being aligned. Make sure that no portion of the computer or
cables interfere with the camera’s view of the road.
•
Connect the setup computer’s network adapter to the camera network. If the installation does not involve a
TLS-301 external light sensor, a direct connection between the setup computer and the camera can be used.
For installations that include a TLS-301, it is preferable to use a local Ethernet switch instead of a local direct
connection to the I/O board. (A direct connection between the setup computer and the camera will disconnect
the camera from the site LAN and thereby disconnect the light sensor as well.) See Figure 16 and follow the
instructions below if you are using a local Ethernet switch.
Disconnect camera’s Ethernet patch cord from the VISCAM 1000 I/O board and connect it to the
switch.
Then connect a new Ethernet patch cord from switch to VISCAM 1000 I/O board’s Ethernet port.
The Setup computer is then also connected to one of the free ports on the switch.
Note: If the switch is running on 24V dc, the I/O board is capable of supplying up to 0.5A on
connector X15 located next to X1 and X3. The pin marked with #1 on X15 is +24V dc.
Figure 16. Example of a network connection using a local switch
4.4 Drive and Park the Setup Vehicle Correctly
•
Park the vehicle on the trigger line. Make sure that the vehicle is parked aimed in the same direction as the
average driver would point their car if they were driving through this section of roadway.