JAI VIS-CAM System, Руководство по установке

Страница: 76 / 112

VIS-CAM Systems
64 Appendix B
Figure 71. J-Panel electrical interface
6.2.3 (c) Ethernet Interface
100 Mb Ethernet interface. The signals are routed directly to RJ45 connector X11. The cable to the camera
must be a Cat 5e or preferably a Cat 6 cable. The wire color marking on the PCB uses standard Ethernet wire
colors.
6.2.3 (d) Power output
Voltage 24VDC from power supply connected to X6 or X7
Current 2A fused
6.2.4 Connector physical Interface
Table 16 Physical interface table
Pin Signal Description
Connection
to
I/O Board
X4
Remarks
1 Ethernet A+ Ethernet signal to gigabit switch pin 1 Cat5e/6 cable white/orange
2 Ethernet A- Ethernet signal to gigabit switch Pin 2 Cat5e/6 cable orange
3 Ethernet B+ Ethernet signal to gigabit switch Pin 3 Cat5e/6 cable white/green
4 Ethernet B- Ethernet signal to gigabit switch Pin 4 Cat5e/6 cable green
5 Ethernet C+ Ethernet signal to gigabit switch Pin 5 Cat5e/6 cable white/blue
6 Ethernet C- Ethernet signal to gigabit switch Pin 6 Cat5e/6 cable blue
7 Ethernet D+ Ethernet signal to gigabit switch Pin 7 Cat5e/6 cable white/brown
8 Ethernet D- Ethernet signal to gigabit switch Pin 8 Cat5e/6 cable brown
9 Gnd Power ground Pin 9 Black wire in Red/Black pair, 20 AWG
10 +24V dc Supply voltage Pin 10 Red wire in Red/Black pair, 20 AWG
11 Vinit + Balanced trigger pulse positive Pin 11 Red wire in Red/Black pair, 24 AWG shielded
12 Vinit - Balance tripper pulse negative Pin 12 Black wire in Red/Black pair, 24 AWG shielded
13 RS485 Data+ for Lane Controller Pin 13 Brown wire in Brown/Black pair, 24 AWG shielded
14 RS485D- RS485 Data- for Lane Controller Pin 14 Black wire in Brown/Black pair, 24 AWG shielded
15 RS485 Data+ for Lane Controller Pin 15 Orange wire in Orange/White pair, 24 AWG shielded
16 RS485D- RS485 Data- for Lane Controller Pin 16 White wire in Orange/White pair, 24 AWG shielded