JAI VIS-CAM System, Руководство по установке

Страница: 47 / 112

System Set-Up 35
VIS-CAM Systems
4.1.6 Connect the Setup Computer to the Camera
•
Position the Setup Computer next to the camera being aligned. If the alignment is conducted in
bright sunlight, shield the monitor screen with a hood to make it visible. Make sure that no
portion of the computer or cables interfere with the camera’s view of the road.
•
Connect the Setup Computer’s network adapter with the camera network. This can be done
directly to the I/O boards X1 and X3 connectors or using a local Ethernet switch. It is preferable
to use a local Ethernet switch instead of a local direct connection to the I/O board. A direct
connection between the Setup computer and the camera will disconnect the camera from the
site LAN and thereby disconnect the light sensor as well.
Figure 36. Example of a network connection using a local switch.
The network connection between the Setup computer and the camera can be established using a local switch.
Two separate ports of the Ethernet Switch are connected directly to the I/O board connectors X1 and X3. The
Setup computer is then also connected to one of the free ports on the switch. If the switch is running on 24V
dc, the I/O board is capable of supplying up to 0.5A on connector X15 located next to X1 and X3. The pin
marked with #1 on X15 is +24V dc.